A Complete Range Of Metal Cleaning
And Surface Treatment Solutions

Telephone: +44 (0) 20 8281 6370
  Click here to request
more information or an MSDS


Combined Lubricant And Corrosion Prevention Compound

MIL-DTL-87177B (revised MIL-L-87177A) Type I, Grade B

SuperCORR A - Aerosol Spray Cans
Click on photo to enlarge image

A proprietary formulation containing extremely long lasting anticorrosion inhibitors, which also give superior lubrication coefficients and protect components against moisture.  This unique, water displacing lubricant, with synthetic corrosion prevention compounds is tested and proven non-flammable and environmentally friendly without sulphates, chlorides or other halogens.

Unexcelled in preventing corrosion and contamination on all surfaces in mechanical close tolerance slow moving components, electrical and electronic equipment, used in humid conditions or exposed to salt water.


Can be used on any metal surfaces to prevent galvanic and fretting corrosion as well as other types of corrosion including uniform, pitting and microbial corrosion.

 Forms a  super thin, hydrophobic, non-flammable lubricant film with anti-corrosion properties approximately 7 microns (0.00028 inch) in thickness and is compliant with U.S. EPA regulations , the European Union RoHS Directives and meets MIL-DTL-87177B (Revised MIL-L-87177A) specifications.

Product oveview


SuperCORR A has the following unique combination of properties:

Displaces both fresh and salt water moisture
Non-toxic, Non-flammable and Non-hazardous
Has a decomposition temperature of 550°F
Will not freeze or harden, retains properties even in high altitude applications
Is extremely resistant to air-drying
Self healing
Does not attract contaminants
Is inert and will not increase or decrease contact resistance
Eliminates surface static electricity, Corona and other electro migration problems in electronic
circuit boards and connectors
Protects against wear, moisture, general and fretting corrosion.
Non-reactive to most plastics
Forms an airtight seal preventing damage to electronics and other surfaces caused by exposure
to acid gases such as Sulfur dioxide (SO2), Nitrogen dioxide (NO2), Hydrogen Sulfide (H2S),
Ammonia (NH3), Chlorine based gases (CL12), and the thermal decomposition by product of
HFC-227ea used in fire suppression systems, Hydrogen Fluoride (HF)

NOTE: SuperCORR Ais to be applied as a preventative measure and will not remove corrosion from an already corroded component or substrate.

Corrosion Protection For Electronic and Electrical Applications
Electronics Corrosion
Corrosion Protection For Electronic
Switches, PCBs, Contacts and Connectors
Corrosion Protection For Railways and Transportation
Railroad Switch Corrosion
Lubricant & Corrosion
Preventative Compound
Corrosion Protection For Marine Applications
Salt Water Corrosion
Lubricant & Corrosion Prevention
For Marine Technologies
Super CORR A is approved for use on Bombardier Aircraft
Aircraft Corrosion
Lubricant & Corrosion Prevention
Compound For Avionics & Airframes
Corrosion Protection For Military Vehicles
Military Applications
Prevent Corrosion On Military Vehicles

A range of corrosion prevention uses and applications

SuperCORR Ais designed to protect and lubricate connectors, terminations and electrical bonds and grounds, relays, fittings, circuit boards, computers, and all forms of avionics such as: controls, radios, transponders, RDF, VOR, DME, GPS, radars, storm scope, flight control computers from moisture, general and fretting corrosion, surface static electricity, corona, and other electro migration problems. Other areas of application include Passenger Master Control Panels, fuel shut-off valves LRUs - flap jack screws, flap tracks, actuators, hydraulic line B-nuts, fuel bladder rails, interior and exterior light sockets, antenna interfacing and any exposed metal surfaces. Use anywhere dissimilar metals may come in contact.


Eliminates electrical resistance failures caused by general and fretting corrosion and to lubricate connectors, nano, micro, and conventional electrical switches, terminal blocks and Busbars, electrical bonds and grounds, relays and switching systems, multi-pin cable connectors, interior and exterior light sockets, plugs, connectors, jacks, and receptacles, as well as electronic printed circuits and microminiature circuits.


The corrosion inhibitor will also protect electrical motors, electronics and switches against surface static electricity, corona, and other electro migration problems and uses a very fast evaporating nontoxic and environmentally acceptable carrier fluid that is non-reactive to most plastics.

Approved in US Tri-service corrosion manuals and military, civilian and aircraft manufacturers, railway and transport operators worldwide.

Electronic circuitry, connectors and components, computers, electrical motors, relays and terminals ; Avionics - controls, radio, transponder, RDF, VOR, DME, GPS, radar, storm scope, flight control computer, light sockets and antenna interfacing; storage batteries; Passenger Master Control Panel, fuel shut-off valves - LRUs, flap jack screws, flap tracks, actuators, hydraulic line B-nuts, fuel bladder rails, and any exposed metal surfaces.

Corrosion protection for a range of industries

Army, navy and air force, electronic component manufacturers, computer repair companies, meter and instrumentation manufacturers, aircraft manufacture and repair facilities, naval construction and repair facilities, electrical motors and fixtures, electronic sign manufacturing and maintenance companies, and many others.

NASA, Boeing Aircraft, Bombardier, Embraer, Lear, Gulfstream, Hawker-Beechcraft, Cessna, Raytheon, Polish Airforce, Northrop-Grumman, Royal Navy and Royal Norwegian Air Force.

See examples of how SuperCORR Ahas helped prevent and control corrosion:

Electronic and Electrical Corrosion


Railways and Transportation Corrosion


Marine Corrosion


Aerospace and Aircraft Corrosion


Military Apllications


Click here for methods and procedures for application.

Click here for technical information.

Further information

For more information or advice please contact us by telephone on +44 (0)20 8281 6370 or email us using our contact form.
CORR-EX products are supplied and supported by EnviroTech Europe Ltd.
SuperCORR A and CORR-EX VCI are manufacturered and distributed in Europe by
CORR-EX Corrosion Protection Solutions


The CORR-EX division of EnviroTech Surface Technologies supply specialist barrier film corrosion protection products based on synthetic materials unexcelled in preventing deterioration and contamination.

CORREX VCI PACK is a corrosion protective packaging used for storage of cleaned machined parts.  

SuperCORR A super thin coatings lubricate and control corrosion to MIL-DTL-87177B specifications (revised MIL-L-87177A)

Industrial Corrosion Protection And Control Solutions

EnviroTech Europe Ltd
46 High Street
KT10 9QY
United Kingdom

NATO Cage Code: U0H05
Company registered in UK No 4170693
VAT No GB765 682 977
© Copyright 2017 ALL RIGHTS RESERVED

Follow EnviroTech:

Telephone: +44 (0) 20 8281 6370
Website: www.corrosion-protect.com